Advanced formulation specially developed for the removal of algae, moulds, lichen and green films from composite decking and cladding. Acts fast and effectively with no need for scrubbing, protecting surfaces from corrosion and damage.
| Size | Product Code | Case Qty | Pallet Qty | Barcode |
|---|---|---|---|---|
| 5L | S72SC C500 | 2 | 160 | 5037832344809 |
| 10L | S72SC C1000 | 1 | 75 | 5037832344762 |
| 20L | S72SC C2000 | 1 | 32 | 5037832344779 |
APPLICATION:
Prep the surface: Brush or pressure-wash to remove loose dirt and let the surface fully dry before treatment.
METHOD:
Apply the product: Do not dilute. Apply using a brush, low-pressure sprayer, or watering can at about 200ml per mÇ until the area is fully wetted.
CLEAN OFF:
Let it work: Allow at least 36 hours for algae to be eradicated. Any leftover debris can be brushed or washed off later, but it isn’t required—cleaning.
SCRUBB Composite Decking Algae Remover & Inhibitor is designed for exterior surfaces around domestic and commercial buildings, including composite decking and composite cladding. It removes algae, mould, lichen and green films while helping protect surfaces from corrosion and damage.
No scrubbing is required. The advanced formulation works by breaking down algae and biological growth on its own. After application, simply allow the product time to work. Any remaining debris can be removed later with light brushing or a pressure washer if desired.
The product should be left to work for at least 36 hours. During this time the algae will be eradicated, and some lichen or algae may take a few additional days to fully disappear or discolour before weathering away.
No. The product is ready to use and should not be diluted. Apply it directly to the surface using a brush, watering can, or low-pressure sprayer for the best results.
Apply approximately 200ml per square metre of surface area to ensure full coverage and effective treatment of algae growth.
The product is effective against black mould, but in some cases residual staining may remain even after the biological growth has been eliminated. Additional cleaning may be required if cosmetic staining remains.
Avoid contact with ornamental plants, grass and other vegetation. If accidental contact occurs, rinse the affected plants thoroughly with clean water. Run-off should also be prevented from entering ponds or water features.
Yes. While the product has been tested on typical composite materials, surfaces and finishes can vary. Always test in an inconspicuous area first before applying it across the entire surface.
Once treated surface is fully dry, it is safe for children and pets.
Got a question that’s not answered here? No problem, get in touch for expert help and advice.
