Advanced formulation specially developed for the removal of algae, moulds, lichen and green films from rendered walls and exterior painted masonry. Acts fast and effectively with no need for scrubbing, protecting surfaces from corrosion and damage.
| Size | Product Code | Case Qty | Pallet Qty | Barcode |
|---|---|---|---|---|
| 5L | S54SC C500 | 2 | 160 | 5037832344304 |
| 10L | S54SC C1000 | 1 | 75 | 5037832344786 |
| 20L | S54SC C2000 | 1 | 32 | 5037832344793 |
APPLICATION:
Prep the surface: Brush or pressure-wash to remove loose dirt/ algae, then allow the surface to dry completely.
METHOD:
Apply the product: Use a bucket & brush or lowpressure sprayer to apply undiluted, covering roughly 200ml per m².
CLEAN OFF:
Let it work: Leave for at least 36 hours. Algae will die off; some discolouration may take a few days to fade.
This product is designed for rendered walls, exterior painted masonry and similar outdoor building surfaces. It is suitable for use around domestic and commercial buildings where algae, mould or green film has developed.
The formulation targets algae, mould, lichen and green surface films that commonly develop on exterior walls and masonry. It works to eliminate biological growth while helping protect surfaces from further deterioration.
No. The product is designed to work without scrubbing. After application, it penetrates and breaks down algae growth on the surface, allowing the treatment to work over time.
Remove any loose dirt or heavy soiling first, then apply the product undiluted using a brush, bucket or low-pressure sprayer. Ensure the surface is fully coated, applying approximately 200 ml per square metre.
The cleaner should be left to work for at least 36 hours. During this time algae will be eradicated and some lichen or growth may gradually discolour before weathering away.
The product is effective against black mould growth, but some residual staining may remain after treatment even though the biological growth has been eliminated.
Rinsing is not always essential. In many cases the product will continue gently cleaning the surface over time, with weathering helping to remove remaining residues naturally.
Yes. Construction materials and coatings can vary, so it is recommended to test the product on a small, inconspicuous area first before applying it across a larger surface.
Avoid contact with ornamental plants, lawns and ponds. If accidental contact occurs, rinse plants with clean water and prevent run-off from entering ponds or water features.
Got a question that’s not answered here? No problem, get in touch for expert help and advice.
